guide reset

RC » Home » hp » 130 Roll loading instructions Hp designjet 130

---

130 Roll loading instructions Hp designjet 130

A FLASHING roll symbol means the roll is empty or a paper jam.

130 Roll loading instructions…

This section is only relevant if your printer has a roll feed installed.
Only one source of paper can be used by the printer at any one time, so if a
roll of paper is loaded and the software requests printing on a sheet
of paper:
• If you have a manual roll feed installed on your printer, you must unload the
roll manually before you can print to a sheet of paper.
• If you have the Automatic Roll Feed installed on your printer, the roll is
automatically unloaded by the printer.
In any case, the roll is automatically reloaded the next time printing to the roll is
requested.
You can cut a roll without unloading it by pressing the OK key (top right key on
the front panel); the paper first advances about 1 cm or 0.4 inch.
1. Set your application to pick paper from the roll feed (only applicable with
the manual roll feed).
2. Select Print from your application.
3. Load a roll of the required paper onto the spindle. Ensure that the roll is the
right way round with the surface on which you wish to print facing up and
that the blue stop on the spindle is pushed in against the paper.
4. Insert the spindle into its retaining slots, with the blue stop on the right and
the black stop on the left as seen from the rear of the printer.
If the paper is glossy, we recommend that you wear gloves to avoid
smearing the surface of the paper.
5. Make sure that the leading edge of the roll is straight and perpendicular to
its side edges and has no irregularities.
6. Rewind any excess paper so that the paper is rolled tightly onto the spindle.
7. Insert the leading edge of the paper into the lower slot in the rear of the
printer. Push the paper in until it encounters resistance, keeping the sides of
the paper rolled tightly so that the paper is aligned properly. After emitting a
‘beep’, the printer will take up the paper.
The printer will check the alignment of the paper.If the paper is
properly aligned, the roll icon will appear on the display,
indicating that the printer is ready to print.
If the paper is misaligned, the printer will eject the paper and the
display will show the misaligned and roll icons; you will have to
reload the paper.
8. Repeat Step 6, so that the paper is tightly rolled onto the spindle.
Sheet paper
Roll paper